Feature

●Multi-functional: Development board for Arduino uses Atmel Atmega328P-AU MCU, supports ISP download and USB download, and Nano has the functions of Boarduino and Mini + USB
●Power Input: Nano is powered via Mini-B USB. Can be powered via 7-12V unadjusted external power source, or 5V-12V stabilized external power supply and 9V battery power supply. Power supply is automatically selected to the highest voltage source
●Improved Version: Nano uses the ATmega328P CH340 chip. Replaces the new and improved version CH340G FT232RL Nano is compatible with Arduino and is used in the official version of the ATmega328P and CH340
●【SAFE AND RELIABLE】: The Nano CH340 development board is similar to the R3 board and is gentle on the smallest full breadboard. This is an improved version of 3.0 ATmega328P with many analog input pins and onboard + 5V AREF jumper. 【Excellent Performance】:Improve transfer rate, increase window stability,solve the problem of FTDI drivers brick non-original chips. ATMEGA328P provides more programming and data memory space
●【Excellent Performance】:Improve transfer rate, increase window stability,solve the problem of FTDI drivers brick non-original chips. ATMEGA328P provides more programming and data memory space


Description

arduino nanoarduino nano

Nano V3.0 Board for Arduino Emith CH340/ATmega328P Nano V3.0 3 Pack Windows Driver Easy to Install

Low power consumption.

Header pins are not soldered yet.

Input and Output

Each digital pin can be used with pinMode, digitalWrite, and digitalRead, as an input or output.

Some pins have special features: serial:0(RX) and 1(TX). Used for receiving and transmitting TTL serial data (RX)

It is also connected to the corresponding pin of the CH340G USB chip.

External Interrupts: 2 and 3

PWM: 3, 5, 6, 9, 10, and 11

SPI Communications: 10 (SS), 11 (MOSI), 12 (MISO), 13 (SCK)

arduino Compatiblearduino Compatible

LED: 13" High value, LED is ON When off, it is low"

The analog input provides 10-bit resolution for every eight and some pins have special features of I2C:4 (SDA) and 5 (SCL).

Other Pins: AREF and Reset Classic LED Project with Nano Board

This sample project shows the physical output that flashes LEDs. Necessary Hardware: 1 x Nano Board 1 x Mini USB Cable 1 x Breadboard 2 x Wires 1 x 5MM LED 1 x 220 ohm Resistor