Test plug that is easy to test water pressure with hand tightening without sealing tape. Water stop plug with air release function!
Test plug for water supply pipes
This is a very convenient plug that can stop water even when tightened by hand, without winding the sealing tape.
New product with craftsman wisdom and experience
Test water pressure for checking after plumbing
Sealing tape costs and effort and is tend to be troublesome
Smooth & Fast
No need for sealing tape or monkey wrenches, hand tightened
It is possible to work and can significantly reduce your work time.
Compatible water pressure up to 1,75 Mpa
Deflation - Slowly loosen the plug
Air and water coming out from the plug, so you can prevent water from splashing out from the screw.
Nominal Diameter: 13
Material: ABS
Please search the video (how to use the kanpla) for free videos.
Patented in Japan.
Product Description
Water pressure test plug for water supply pipes Comes with a seal that does not require adhesive tape. Easy to tighten by hand and screwdriver Patented.
Note (Disclaimer) > Please read
Instruction manual (English language not guaranteed)
1. Prepare before use, to prevent water from splashing, please be sure to take care of cultivation before use. Remove debris from the seal crimping part before use.
2. Turn the plug by hand and tighten it gently. Plug must be screwed straight If it is oblique it will cause damage to the screw, deformation of the packing, or damage to the main body and cause water leakage. Please do not use adhesive tape.
3. Tighten the gasket to a light contact, so there is no water leakage from the side.
4. Light pressure with a test pump. (approx. 0.5 Mpa).
5. Lightly loosen the plug with your hand and make sure that the air is completely removed from the tube, and the water will come out. (Please note that the water will shatter from the plug)
6. Turn the plug with a screwdriver, etc., and screw it again.
7. Installation under excessive torque may cause damage.
8. Press again to the specified pressure. (Allowable water pressure below 1.75 Mha).
9. Water leakage of plug contact during the boosting, there is a possibility that there is a lack of tightening. Please tighten and tighten the half rotation depending on the driver, and try again.
10. After completing the test, make sure that the pressure in the pipe has been loosened and removed.
[Precautions]
This product is manufactured for water pressure testing, so please do not use it outside of testing.
Please use in cold water.
Please use the water pressure below 1.75 Mpa
Can be reused up to 5 times. Please replace with a new plug.
Please remove debris from the seal crimped parts such as faucet fittings and plugs before using.
Please store the plug and seal in order to avoid damage during storage.
Please do not use any other than the equipped gasket.