- The soft series is popular even in the traditional drift spring series with a total length of 1.2 inches (30 mm), drift springs - 1.3 inches (32 mm) and a softer set of 5 individual items! Product description is from RC926 support driver, chin pilano.
- Long type to make it easier to pull out the original performance of the soft spring.
- It is easy to ensure the height of the car and reduces preloading, so it is easy to reproduce more weight movements.
■ For 1.2 inches (30 mm), it has a good balance between the roll and pitching direction, making it easier to move the load!
■ Basically, it is a longer spring that is soft & softer so if you transition from the 30mm series, you can experience the difference of 2mm by selecting the same one.
■ Its performance also exhibits the final battle of 2013 PRORC! A single run or chase wins! And the 2013DR1GP wins!
■ Especially the rear is the stickiness of the roll direction, and the extrusion in the pitching direction is increased.
■Enjoy the fun of controlling the load!
■ We think it is the best spring for current radician scenes!
■ This drift spring is made of high quality springs that have been treated with appropriate heat treatment for stainless steel spring material, and finished with precise edge polishing.
■ Drift Springs - 30 Ultra Soft 27 (White) to Ultra Soft 31 (Black) with 5 types of springs that are 0.08 inch (2 mm) long, total length 1.3 inch (32 mm) is now available.
■ 5 types of 1.2 mm wire diameter with 1/4 (0.25) different coils, making setup more detailed than previous models.
■ It covers low grip road surfaces from high grip roads, such as asphalt, carpet, concrete, and P-tile, and has good traction and a spring. This spring is recommended for both AWD and RWD.
■Drift Spring-32 Ultra Soft 39, 40, 41, 42, 43 Data
Ultra Soft 39 [White] (KN-DS39) Rolls: 10.00
Ultra Soft 40 [Blue] (KN-DS40) Rolls: 9.75
Ultra Soft 41 [Yellow] (KN-DS41) Rolls: 9.50
Ultra Soft 42 (Red) (KN-DS42) Rolls: 9.25
Ultra Soft 43 [Black] (KN-DS43) Rolls: 9.00
Total length is approximately 1.3 inches (32 mm).
Each wire diameter is 0.05 inch (1.2 mm).
The markings have 4 lines on the face of the face.
■Made in Japan.
The total length is about 1.3 inches (32 mm), so it is recommended to be used with other damper compatible products such as long spring cups and down retainers.
When replacing springs, be sure to check the height of your vehicle. Too high or too lower than the original car height may cause a discomfort in the running characteristics and operation and the springs will not work. When combined with the chassis compatible with damper ends and parts that are adjustable to the height, you can reduce the preload in excess spring and enjoy the original performance of the spring.
Some dampers cannot be installed in some cases.
■The image is a product image and a comparison table for softer sets.