Feature

●Shaft diameter: 0.25 inch (6.35 mm) shaft; Applicable range: 1# is 0.25 to 0.39 inch (5 to 7 mm) screws; 2# is 0.25 to 0.47 inch (6 to 8 mm) screws; 3# can be used with 0.4 to 0.7 inch (8 mm) screws
●This crushed screw remover is forged from premium steel, hardened at high temperature, has a sharp edge, strong practical, high efficiency and high performance, easy to take out
●This 10 thread extractor set allows you to remove screws and water pipes that are not lost by regular tools due to damage, rust, and adhesion
●The 0.25 inch (6.35 mm) shaft thread repair kit can be used with electric drills. Suitable for DIY, home and general architecture/engineering
●How to Use: Drill the hole deep on the drill bit side with an electric tool, turn it to the other side, slowly rotate the left and remove the broken screws. Removed screws can be easily removed in less than 10 seconds


Description

10 Thread Extractor Set, 5 Different Screw Extractors

Shaft diameter: 0.25 inch (6.35 mm) shaft

Applicable range: 1# can be used with 0.2 - 0.3 inch (5 - 7 mm) screws, 2# is 0.2 - 0.4 inch (6 - 8 mm) screws, 3# can be used with 0.4 - 0.6 inch (8 - 11 mm) screws, 4# can be used with 0.6 inch (14 - 14 mm) screws.

Perfect for peeling, breaking, jamming, damaged or removing screws. Easily pull out embedded rusted, painted screws and bolts

This tool works with allen bolts, small screws, lag bolts, wood screws, hex bolts, sheet metal screws, and round bolts.

Screw Extrusion: Suitable for removing screws or broken screw nuts on hard wood or wooden floors. Easily remove slugged screws and bolts (flattened screws, bolts).

Some of the common drivers can be removed and will not disassemble damaged bolts, screws, bolts or pipes. Reverse screw bit easily removes screws, bolts, studs, and threaded pipe fittings.

Note: Not compatible with stainless steel screws. Suitable for normal drills and electric hand drills, not compatible with hammer drills.