The shift pattern emblem in the red color that you have been looking for.
It matches perfectly with red stitching, Kinhuan, Chinchilla, etc.
Rare Lower Left R 5MT Shift Pattern Emblem
Recommended for Bluetech Canters (current).
Made of highly transparent polyurethane resin with a domed finish.
It combines a beautiful 3D gloss and high durability with UV protection.
It gives your interior a luxurious look that is different from ordinary stickers.
Fits all 5-speed manual vehicles identical to the pattern shown
Just stick it on the side of the shift boot or the shift panel.
Size (H x W x D): 0.6 x 0.9 x 0.08 inches (16 x 2
It will take almost the same dimensions as the original car manufacturer shift pattern label to ensure proper application area.
Simple and timeless design with no extra logo or decoration
Tuningfan Original Product
By applying red color to the base of the metal hairline,
The color of this product is similar to the anodized finish that changes depending on the angle you see.
In consideration of matching with red stitches such as shift boots and seats, it is slightly darker red.
86/BRZ, ZC32S/ZC33S Swift Sport, ND5RC Roadster, VAB WRX STI etc.
Red stitching works well with sport car interior
The shift knob without the shift pattern will not pass through the vehicle inspection.
Driving on street is essential to install these shift pattern plates.
Recommended for those who do not have an external shift knob with pattern plate.
The adhesive of this product is the most "strong adhesive" material.
If there is dust or oil on the surface, the adhesive strength will be greatly reduced.
If polishing agent is applied,
Remove carefully with part cleaner or alcohol tissues before sticking.
After peeling off from the separator (mat), please stick it with care not to touch the adhesive surface.
Apply pressure to the entire surface and press it close.
The initial adhesion of the adhesive takes up to 24 hours to be stable.
Avoid moving or repositioning.
If the temperature is less than 22°F (10°C), it will be difficult to stick on, so you can use a hair dryer.
Please warm it a little before sticking.
Common plastic (PE, PP material) for flat or gentle secondary curved surfaces
Intended to be applied to interior panels
For sticking to textured surfaces, curved surfaces, and soft touch paints.
Please use the included double-sided tape (JIS Super Strong, Made by 3M).
Dome: Polyurethane resin (non-yellowing)
Pattern notation: hairline laser imprint
Adhesive: Strong adhesive