This is a JAN/EAN code registered part that has been selected as one of the only authorized original custom parts in Japan on Amazon and major shopping sites. ★How to Install: The drive chain guard attached to the back of the original cover can be used as a direct flow of the MD30 parts and then install with the special flange bolts included in the set. The reinforced cover is made with regulatory measurements, but please be careful when considering that the bolt holes may not match due to deformation or deformation of the chain guide. In that case, please replace it with a brand new genuine drive chain guard and install it properly. This product is made with a 1-piece construction (one-piece type) to ensure installation, and the special flange bolts and washers are used to make installation safe and reliable, and to strengthen the tear strength and vibration. (Applicable Vehicles: XR250, Motard, BAJA All Year (Models: MD30) (Model Number: MD30) ) (XR Series Oil Line Reinforced Bolt Set) (XR Series Oil Line Reinforced Bolt Set), (XR 250 Series AI System Cancellation Set), (Genuine Carburetor Engine Breather Strengthening Set), (Direct Ignition Plug Enhancement Cap) (engine. Please check out the headcam ASSY enhancement set), "genuine carburetor inner parts enhancement set", and "genuine regulation / rectifier replacement set for reinforce set. 🔴 Buy more than one and we will ship them together. You will see our original creations "generic product copied", but this is an important part that will affect the protection, so please consider your car now when you purchase. ★ We always produce and sell parts that are based on maintaining basic performance of normal engines in order to ensure a long lasting and secure ride with confidence.
1. Flange bolts are used with practical strength, but do not apply excessive force over the prescribed torque. In addition, if the torque exceeds the prescription is too tight, the crankcase and chain guide may be damaged or deformed. 2.If the flange bolt or chain guides are not sufficiently installed, it is very dangerous to contact drive chains or drive sprockets. Also, periodically inspect flange bolts and sprocket covers to prevent loosening. 3. Do not process excessive cover over the current status. Insufficient strength and deformation and damage. 4. Reinforced covers are made with regulation dimensions but the bolt holes may not match due to distortion or deformation of existing chain guides. In that case, please make sure to replace the original chain guide (Part Number: 11352-KCZ-000) and install it properly