How to Apply
1. Measure the glass and cut it to the desired size of the product (please cut the glass film length and width by about 0.8 inch (2 cm) than the actual size for adjustment).
2. Clean the area around the glass and window cleanly. Spray the glass surface with a large amount of water drips (The cleanliness of the glass will affect the finish, so please clean it carefully. )
3. Peel off the protective film (transparent) and spray the water diluted with water or detergent with a mist on the surface of the glass film.
4, Check the location of the application, paste it on the top, there are two ways to do it:
1) Generously spray it on and then you can adjust the position by hand.
2) Apply the window film over the glass surface, press the surface with towel or card, and continue to stick it slightly.
5, Remove excess moisture and air from the center to both sides (*Recommended to deflate with a towel or card; *Cards may mark the window sheet, so please be careful when deflating with cards).
6. If there is any excess part, cut the excess part with a cutter and remove the last water and done.
Note:
*If the corners do not deflate or the corners are peeled off, you can use it repeatedly, so please open the corner, spray a lot again on the glass surface and reapply it.
*Can be used repeatedly when undamaged.
*It is recommended for first-time users as it is easier to apply it by spraying as much water as possible.
*If the glass area is large, it is recommended to use two people.
*For more information, please search "About Shackcom Window Sheet" on YouTube for installation videos.