This forged peg uses "Martensitic stainless steel 420J2" that boasts a high level of hardness. Furthermore, tempering at 980 degrees Celsius and tempering at 700 degrees Celsius and applying strong pressure to heated steel to achieve the ultimate peg with a hardness of over 250 HB. Therefore, it is easy to hit on hard surfaces and is hard to break. It can be used in most places such as gravel and hard ground, and is strong enough to shatter stones.

1. Anti-Shedding Design: When the hooks stick to the ground, the stake will not rotate and prevent rope from falling out. 2. The round hole is designed to allow the peg hammer hook to be hung just right.Can also be used for rope attachment. 3. Oval column head with oval column shape, flat and easy to start. The pulling direction of the rope is designed with a thick material, so it can withstand the strength of the rope.

The pointed tip is flat to prevent injuries from collision. No welding surface, not only looks good, but it can be used for a long time. Since the stainless steel material is forged, there is no paint on the surface.Therefore, you dont have to worry about rusting by hamming the paint peeling off as shown in the picture.

Stainless steel does not absolutely rust.Rust resistant.

The chlorine content in the soil may destroy the passivate film, so please clean the dirt before storing it.

If rust gets stuck to the surface, remove rust with a melamine sponge and store it.

Guy lines and pegs are angled right (90 degrees). The pegs are tilted in the opposite direction of the tent at a 60 degree angle to the ground.If possible, you want to drive the guy line until it is closer to the ground. With a peg hammer, you can use the hook on the back to pull it out using the principle of levering. Pull another peg on the hook of the ground and pull it out with a light twist. Please wash it with water and dry it as possible.