Feature

●Material: ABS, environmental protection and harmless.
●Arnico 5 magnets bring more focus and dynamics
●Bobbin is protected by wax string for coil protection
●Pole Spacing: 0.5 inches (12 mm) (center to center) Pickup R: 0.4 inches (9.3 cm) Kohm
●Colour: Black Material: ABS Battery: a 6F22 9V battery (not including battery); Product Size: 9 * 5.5 * 5cm line length 54cm Features: Material: ABS, eco-friendly,harmless. Alnico 5 magnets add more focus and enhanced dynamics ● The bobbins are protected by waxed string for added coil protection. Pole spacing: 12mm (center to center to center Pickups R: 9.3 Kohm


Description

301301

Pickup Modulation Quick Start

1.Control knob basic setting Set the volume, microphone blend, and notch knob off and adjust bass, mids and treble knobs to the exact center position.

2. Turn on the power. Connect pickup to speakers or amplifier with 1/4" instrument cable. When the battery indicator (batt) flashes rapidly, it means that the power supply is connected properly.

3. Official activation: The volume knob is larger, at the same time adjust the three knobs appropriately according to the sound effects you like, bass, mids and highs.

4. Mixing with microphone: (mic blend) large microphone blend knob, allowing you to mix the built-in microphone (and pickup)

301301

Features of the Pickup Control Knob

Volume: In order to achieve the silent effect of the guitar, the volume button should be as large as possible, and the assumption of not being able to be as large as possible to produce distortion or sound feedback.

Bass (base:) When this knob is larger, the sound of the guitar will become more saturated and thick.

Middle:Turn the middle knob to the left,then increase the volume to get the smooth sound effect that is "knockout".In addition, the center knob can be added to the right (default is in the middle position), allowing the guitar mid-range to ring like a "hard-bited" sound effect.

Treble: (This knob can be adjusted to reduce the roundness of the guitar tone, at the same time you can control the sound effects properly.

Notch: Adjust the notch filter to remove low-end feedback.Increase the volume, slowly rotate the notch to the right until the feedback is eliminated.

Phase: (Phase): Use phase switch to improve bass response at low volume and reduce loud feedback.

Mic Trim: The side of the preamp box has a dedicated microphone volume control. Adjust the microphone blend knob to the exact center position, then use a slotted driver to properly adjust the microphone trim until the balance between the microphone and pickup is satisfied.

301301

301301
Fishman Presys Blend 301 Fork Acoustic Guitar Pickup Microphone Beat Board

Item: Double mode piezoelectric pickup preamp eq tuner 301

Brand: Fishman

Pick-up Material: High quality ABS plastic

Color is same as black

Pick up range: use all types of acoustic guitars

Weight: 160 sets

Feature Introduction of Pickup Control Knob 2

Mic Blend: The control of this knob determines the balance effect between the built-in microphone and the pickup signal. Adjust knob from center to left to increase pickup soundConversely, adjust the knob from center to right to increase microphone sound. Assuming a loud volume setting, a small amount of microphone effects.

Tuner: Adjust your device by comparing the following "light" situation.

Battery(Battery): When the "batt" battery indicator is still, it will notify you that you need to replace the battery. Turn off your device and turn off the tuner when not in use to save energy. When replacing the battery, you need to first turn the latch on the Fishman logo to open the front level cabinet, then replace it. When installing a new battery, be careful not to reverse the positive and negative polarity of the battery.

Below are some manufacturer parameter settings for reference.The sound from different guitars and different speakers is very different, so these parameter settings are for reference only.You need to adjust it with your ears. Distinguish sound.

301301

301301

301301

301301

Reference Setting 1: Finger Style and Solo ModeUse this setting to get strong bass and translucent treble.

Reference settings 2: If the medium frequency is too high, the sound is hard and dynamics are not enough.This setting to cut medium frequencies may be the sound you need.

Reference Setting 3: To make the sound effect more uniform, the strum timber requires balance of high and low frequencies.

Reference Setting 4: Debugging in the band, playing guitar is not the same as adjusting the balance of other instruments in the band.In this case, you need to dampen the bass and increase the treble.The bass of the guitar is too heavy, so it is easier to generate feedback.It will also interfere with other low music devices.