Feature
●We will contact you through the order description after payment has been processed. Please check the message "Important" "Hanko Festival" in the message center within the Amazon account service → message → "Buyer/Sellers message. Please copy and paste the URL in the message, open it in a separate browser and enter the production content in the form. Production will be done after the order has been confirmed
●It will be made up to 4 lines. The width and size of the letters may be adjusted depending on the number of letters
●If you would like a vertical layout, please fill in the form sent by us. The number will be changed to Kanji Number. If you would like the numbers left in the number, please also let us know if you want it
●For vertical writing, the zip code will be printed horizontally on the top
Description
Easy and continuous printing of invoices, invoices, envelopes, postcards, etc.
Not only can it be used as a corporate address, but also for personal addresses. Great for everyday use and New Years notes.
About Re-Inking:
About Ink
Ink pad is set on the side of the body.You can remove this to refill the ink.
1: Remove the ink pad from the main unit.
While lightly pressing the white button on the side, there are areas where it will lock and lock in place as you would would like an imprint.
2:About the lock
When you lock it in a step 1, it will look like the "lock state" in the picture above, leaving a little gap between the rubber stamp and the ink pad.
Please be aware that the markings and pads are ground up like "normal" when removing the ink pad may cause the pad to be unremoved, or damage to the marking pad
3: Push out the ink pad
Squeeze out the ink pad with your finger.If you are narrower and difficult for your fingers to get into, press it with your finger until you hear a audible click, then press it with a ruler.
There is no decision in the direction of the ink pad to push it out, so you can use it on either side or left side.
4:Pull out the ink pad
Gently pull out the ink pad that came through the middle
5: Re-inking.
Drop a few drops of ink onto the removed ink pad.Please refill it with a look to prevent it from overfilling the ink.
If the ink has a high viscosity, please stretch it with the tip of the nozzle and it will penetrate quickly.
6: Re-install the ink pad
Insert the ink pad into the main unit.It can be used on either the left or right side.Insert deep until you hear a click.
The lock will come off by pressing it lightly as you would with imprinting.
