Feature
●We will contact you through the order description after payment has been processed. Please check the message "Important" "Hanko Festival" in the message center within the Amazon account service → message → "Buyer/Sellers message. Please copy and paste the URL in the message, open it in a separate browser and enter the production content in the form. Production will be done after the order has been confirmed
●This item is a set of 0.8 inch (20 mm) square stamp and a rotating address stamp. (*The address mark does not come with a cap. )
●Ink Color: Square stamp "Verme" / Rotated address stamp "Black" / Maximum letter count: Square stamp / 16 characters rotated address stamp / Up to 4 lines of up to 23 characters per line
●In order to balance the characters, the rubber stamp may be made with a "mark" or "Noji" after the company, business name, or group name. If you do not need it, please refer to the notes column
●The rubber corners will be written horizontally if the letters or numbers are included in the engraving content. If you would like to write vertically, please write it when ordering
Description
Speed impression! This is a stamp that does not require sinks.
One hand! Easy to use just push it down.
About Re-Inking:
|
|
|
|
|---|---|---|
About InkInk pad is set on the side of the body.You can remove this to refill the ink. |
1: Remove the ink pad from the main unit.While lightly pressing the white button on the side, there are areas where it will lock and lock in place as you would would like an imprint. |
2:About the lockWhen you lock it in a step 1, it will look like the "lock state" in the picture above, leaving a little gap between the rubber stamp and the ink pad. Please be aware that the markings and pads are ground up like "normal" when removing the ink pad may cause the pad to be unremoved, or damage to the marking pad |
|
|
|
|
|
|---|---|---|---|
3: Push out the ink padSqueeze out the ink pad with your finger.If you are narrower and difficult for your fingers to get into, press it with your finger until you hear a audible click, then press it with a ruler. There is no decision in the direction of the ink pad to push it out, so you can use it on either side or left side. |
4:Pull out the ink padGently pull out the ink pad that came through the middle |
5: Re-inking.Drop a few drops of ink onto the removed ink pad.Please refill it with a look to prevent it from overfilling the ink. If the ink has a high viscosity, please stretch it with the tip of the nozzle and it will penetrate quickly. |
6: Re-install the ink padInsert the ink pad into the main unit.It can be used on either the left or right side.Insert deep until you hear a click. The lock will come off by pressing it lightly as you would with imprinting. |
