Curing Start Time: 5 minutes. *Hard to move time: 10 minutes. *Time to reach practical strength: 1 hour (70 kgf/cm²). *After hardening: hard.
Heat resistant up to 58°F (240°C); Strong & Fast hardening: Can be filled with tensile shear strength holes of over 1000 kgf after 1 hour at an adhesive area of only 5.9 cubic inches (15 cm); Does not drip even on vertical surfaces; Can be cured and drilled (after hardening) for outdoor use, chemical resistance and water resistant.
Acetone XX
Methanol.
Toluen◎
10% NaOH water.
10% salt water.
Distilled water Yes
For strong and strong adhesion, such as metal and plastic, filling meat, and filling holes in areas where heat is applied, and filling the holes.
|
|
|
|
---|---|---|---|
The adhesive surface is not sufficient for small parts (such as eyeglass frames). |
|
|
|
Bonding parts of fluorine resin, polyacetal food directly contact with precious metals; For use with organisms and skin, such as breeding aquariums, ponds, food containers, bathtubs, and other areas that are submerged in water.
|
|
|
---|---|---|
Mix.Remove dirt, rust, oil and other contaminants from the surface to dry thoroughly. Squeeze out an equal amount of A and B agent and tighten the cap.Mix with a spatula until uniform |
Apply to one sideApplies evenly to the adhesive surface within 5 minutes. |
Sticks together.Stick it together and secure it with tape or string, and leave it still. After using, tightly seal A and B cap to prevent the gap between uses. |