Quantity: 20 pieces.
Type: Snap-in
[Working Force] 1.27N
[Direction] Top push
[Travel amount] 0.01 inch (0.3 mm)
Operating Life (5 mA 5 V DC)] 1,000,000 cycles
[Initial contact resistance] 100 mΩ max.
Stem Tone: Black
Stem: Flat stem
[Series Type] Sharp Feeling Type
Operating Temperature Range: -40 to 185 °F (-40 to 85 °C)
[Maximum rating] 50mA 12V DC
[Minimum rating] 10μA 1V DC
[Electrical Performance]
Insulation Resistance: 100 MΩ min. 100 V DC for 1 min.
Withstanding voltage: 250V AC for 1 min.
[Durability] Vibration Resistance: 10 - 55 - 10 Hz/min, total amplitude 0.06 inch (1.5 mm), X. Y. Z 3 directions, each 2 hours
[Weather Resistant]
Cold resistance: -40℃ 96h
Heat resistance: 198°F (90°C), 96h
Moisture Resistance: 140°F (60°C), 90 ~ 95%RH 96h
RoHS Compliant
■Soldering conditions
For auto-dips.
Flux adsorption: Not adheres to the mounting surface of the part
Pre-heat temperature: 222°F (100°C) max.
Preheat time: 60s max.
Solder Temperature: 558°F (260°C) max.
Soldering time : 5s max.
Number of solders: Less than 2 times
For hand solder:
Solder temperature: 350°C max.
Continuous soldering time: 3s max.
Soldering iron capacity: 60W max.
1. Do not clean the Tact Switch R.
2. Do not allow flux to enter from the top of the tact switch R.
3. Do not apply flux over switch terminals and PCB component mounting surfaces beforehand.
4. If you do the second time of soldering, please allow the switch to return to room temperature.
5. Please use the flux specific gravity of 0.81 or higher. (Equivalent to Tamura Kaken EC-19S-8 Co., Ltd.)