Feature(may vary by option.)
●For Pxmalion ABS 3D printer filament, the material only weight is 2.2 lbs (1 kg). Product weight is 2.9 lbs (1.4 kg). Gentle Tip: Spool dimensions: Width 7.9 inches (200 mm), Hole diameter 2.1 inches (54 mm), Thickness 2.5 inches (63 mm)
●The output temperature (melting point) is higher than PLA resin to output if it is not high (about 230 - 260 degrees Celsius). Not easy to deformation up to about 200°F (100°C)
●Easy to warp → The amount of resin shrinkage when the temperature drops is larger than PLA. You dont have to worry about the output of thin and long, flat objects
●Easy to Process: Much easier to sand, etc. compared to PLA. Very easy to remove support material
●Toughness: It is slightly flexible than PLA, and is resistant to bending and stretching
[Transparent Clear]
[Black Black]
[White White]
Description
Pxmalion ABS 3D Printer Filament is the best ABS filament! The printing is smooth and smooth. Beautiful color and gloss. Choose from a variety of colors.
Also, for Pxmalion ABS 3D printer filament, the material only weight is 2.2 lbs (1 kg). Product weight is 2.9 lbs (1.4 kg). Super high cost performance. \(*🐭0 ) ♪
Print Performance
Due to the nature of the material, ABS is very easy to print from the hot end. No need to worry about jamming or hardening because any extruder is squeezed smoothly. But it will be a little difficult to handle after being squeezed. Because it has the ability to shrink when it cools. This is a problem where it floats away from the bed. Or taller prints may tear off the layer. Therefore, a heated bed is essential for ABS printing.
ABS is very fast to print. You can set your ride up big and faster. Less line pull, so attraction is usually a fraction of the cost.
Strength
ABS is very strong when you print at the right temperature and seal the layer.
ABS is flexible and can bend under pressure without breaking.
When should I use it?
ABS is good for anything that might fall off, use in hot environments or rough handling. You can think of knife handles, car phone mounts, phone cases, toys, wedding rings(Im made of black ABS), etc. In short, it is suitable for most things.
When should I use it?
Prints cannot be printed with printers that do not have a heated bed. If you want to print a large one without wind or temperature retaining equipment, you must be careful of peeling and cracking the layer.
▼ Specifications
- Material: ABS
- Printing temperature: 230℃~260℃(Recommended temperature: 230℃~245℃)
- Heated Bed Temperature: 80℃~100℃
- Recommended Printing Speed: 40-90 mm/s
- Filament Diameter: 1.75mm
- Spool Dimensions: Width 200mm, Hole Diameter 54mm, Thickness 63mm
- Application: Universal (Suitable for dobu 3D printer and 3D printing pen)
- Material Weight: 2.2 lbs (1 kg).
- Product Weight: 1.4KG
Color: Transparent/Blue/Green/Purple/Black/Red/Silver/White/Yellow/Orange