[5L x 1 bag]
Ion Exchange Resin for Pure Water
Ion exchange resin is fine granular and may cause accidents such as falling, if spilling around the floor or other areas when filling or replacing the tank.Oxidants (nitric acid, etc.) may affect ion exchange resin and cause fever reaction when conditions are combined.
Industrial grade ion exchange resin mixed in 1:1 with strong acid cathic exchange resin and strong base anion exchange resin for pure water production. Purity water is filtered by a pure car washer, removing the calcium that causes the scale, so you can wash your car without worrying about the scale.
|
|
|
|
---|---|---|---|
Set a sandbag with a bucket or other bag.Set the bag in a stable location such as a car wash bucket and prepare for replacement. It is recommended that you curate your floor as it becomes slippery, dangerous and difficult to clean. |
Rotate the lid to remove from tankRotate the top head (lid) to remove the tank from falling over. Please note that it is easy to slip when wet. |
[Check] Check thread threads.Check that ion exchange resin is not adhered to the thread portion, and rinse with water if it is adhered to it. Leaving it on the threads may cause water leakage. |
Rinse with waterRinse the entire head with water. Flush old ion exchange resin clean. |
|
|
|
|
---|---|---|---|
Emits ion exchange resin.Discharges ion exchange resin that is securely carried in the tank. If the contents are difficult to get out of the way, please fill it with water and repeatedly discharge it. The tank is heavy, so please be careful of falling or falling off. |
Insert new ion exchange resinInsert new ion exchange resin into the colored-shaped tank. The funnel is used in the image, but please try to use it as a substitute for newspapers etc. |
Shake tank in the middleShake the tank itself in the middle of the ionic exchange resin in the tank to even. When placed unevenly, it will overflow tank capacity. |
Ion exchange resin insertion complete.After completing the ionic exchange resin, check the ion exchange resin attached to the mouth of the tank. |
|
|
|
|
---|---|---|---|
Fill the tank with waterFill the tank with water and wash off the ion exchange resin attached to the mouth of the tank. Be sure to fill the tank with water.If you insert the head without adding water, the parts may fall off and cannot produce pure water. |
Insert the head partInsert the head into the tank with water and ion exchange resin. Please insert the head part slowly and be careful not to overload it. Excessive swinging and entering will cause damage to the head part. |
Insert slowly until the lastApply your weight slowly while inserting it to the end. Be careful not to let the tank fall over. |
Close the head (lid)Close the head tightly while holding the tank and be careful not to damage the parts. The amount of pressure is sufficient to prevent water from leaking during use. Finally, test for pure water production. |