The Ray Compressor has been popular as a very natural compressor, and the Ray Compressor is back to Rev.3.0 with internal structure brushups and significant added functionality.
The sound of the compressor part is the perfect base for sound making, and the equalizer part has been strengthened to 3 bands, and the range switch function allows you to create a wider range of sound that can be used with the base.
■ Control
PRE GAIN switch
Adjust the level of input HI is set to send signal to effect circuit at the highest level. The compressor part may be distorted depending on the output level of the guitar or base pickup, or the setting of the SUSTAIN knob. Please set HI first, and change MID, LO and settings if distortion occurs.
SUSTAIN
Clockwise increases gain. The main control of the compressor part of the compressor is amplified by large inputs to produce longer sustains while maintaining volume.
ATTACK
Adjust attack time. In the smallest direction, the attack time is faster (as compression starts right after picking) and slower at the maximum direction (leaving a large input for picking and slowly beginning to compress).
VOLUME
Use it to cut larger volumes when adjusting the equalizer to distort.
Treble/Bass
Boost Cut High and Low Shelfing Filter, almost flat at 12 oclock.
TREBLE-RANGE/BASS-RANGE switch.
Changes the range (cut-off frequency) of TREBLE and BASS controls.
MID.
Parametric equalizer to boost and cut the midrange, almost flat at 12 oclock.
MID-FREQ
Set the center frequency of the parametric equalizer and increase the frequency clockwise
MID-Q
Changes the Q of the parametric equalizer (the width of frequency band where the effect works). NARROW is the narrow and peeky setting, the WIDE is wide and the MID is in between.
Please refer to the "Equalizer" for details about the equalizer.
■Size
Length 4.7 x Width 3.9 x Height 2.1 inches (120 x 100 x 54 mm).
Includes protruding parts such as switches and jacks.
■Other specifications details
006P (9V) battery or 9VDC adapter (center minus / 0.08 inch (2.1 mm) pin / 9 vDC).
Current Consumption: Approx. 29 mA
■About bypass switch
True bypass system prevents active circuits from passing through bypass
Mechanical relay control automatically switches to bypass state when power supply is out and returns to the last time it is powered again.
■About voltage monitoring function.
This unit monitors the input voltage at all times, and when 9V is below or above a certain point, the LED flashes and automatically bypass state. Please check the remaining battery level and voltage of the power supply.
■Important information
Failure due to use of a power source that differs from the above specifications is not covered by initial defects and warranty.