Feature

●High Frequency Drive System
●This device is used in electrical model cars according to the following information of the selection range setting
●Automatically finds the center
●Front and rear functions for cars, boats and use of low-resistance electrofield effect inner tubes
●Great budget speed control is upgraded from the machine.


Description

Jaimenalin is a legally registered trademark. Only those authorized to sell items under Jaimenalin are available Jaimenalin wish you a happy shopping experience. 2 x 320A Speed Controller ESC / Reverse RC Carbon 1/81/10 with Brush Brush Brush
Electrical Parameters: Support: Ni-MH NiCd batteries 4-6 groups (4.8-7.2V) Lithium batteries 2 groups (7.2V)
Move by many current: forward 320 A240 A reverse brake 250A
BEC Output: 5.6V, 2A
Forward Current: 320A
Back Current: 240A
Voltage Range: 4.8 - 8 .4 V
PWM frequency: 1.5KHz
Size: 34 x 34 x 30 mm
Material: Plastic + Metal
Weight: 47g
Description:
1. Battery must be connected correctly. On both ends of the wiring board, the red line is positive, and the black is negative.
2. Turn on the power switch, if there is no input signal, this motor is """" beep? Beep? It will emit a beep sound and alarm sound. When there is a signal, the alarm will stop.
3. Turn on the remote control, adjust the trimmer in the middle (red and green light will turn off. Press the throttle forward to the RC car progresses, green light will turn on. Pull the throttle back to break state. The size of the brake pull back makes it tighter. Release the throttle in the middle and pull the pack again. The red light will light up, and the RC car will go backward.
Note:
This product cannot be used in humid environments.
Make sure the power supply is not negative.
Color: As shown
Package Contents: 2 x 320A ESC
Note: The color and size of the actual item may vary slightly from the color and size on the website due to lighting and display conditions. The margin of error for the measurement is +/- 0.4 - 1.2 inches (1 - 3 cm).