[0.4mm UPBOX & AFINIA H800]
[0.5mm For AFINIA & UP only]
[0.4mm For AFINIA & UP only]
[0.3mm For AFINIA & UP only]
[0.3mm UPBOX & AFINIA H800]
Features:
Japanese nozzle with fine craftsmanship.
Comes with a 0.01 - 0.02 inch (0.3 - 0.5 mm) diameter nozzle that is not found in the manufacturer genuine.
By reducing the diameter of the nozzle hole, the precision of the molding is increased.
The 0.01 inch (0.3 mm) nozzle provides increased dimensional accuracy and edge sharpness. On the other hand, please be aware that it is likely to clog soft materials such as flexible filaments.
0.02 inch (0.4 mm) nozzle is standard.
Note:
Comes with some disassembly and assembly skills.
Equipped with an older type nozzle heater (V2). Does not fit Plus2.
The laminate pitch above the nozzle hole diameter will leave a gap and cannot be used successfully.
The smaller diameter nozzle is more prone to clogging and other troubles as it is likely to occur.
■Disclaimer
Please be aware of this in advance that DIY work is at your own risk.
DIY work is at your own risk. Please be aware of this before purchasing