Feature
●Working range: 60-150mm
●Shaft length: 180mm
●Number of nails: 2 and 3 jaws can be changed
●Can be hung on the outside/inside: It is convenient to use as you can hook your nails from the outside or inside of your gear
●Application: Can be used to pull out bearings, gears, pulleys
Description
Gunpla Gear Puller with 2 and 3 Jaws Changeable 5.9 inches (150 mm)
Specifications:
Working range: 60-150mmShaft Length: 7.1 inches (180 mm).Screw Diameter: 0.5 inches (12 mm) Axis Center Stroke: 5.1 inches (130 mm) Pulling Load: 2.7 tons
Attachment
1 x Pull Ring
Claw x 3
6 x Pull Tabs
6 x Screws
1 x Shaft
Double hole design
Double hole design
Adjust the hole for a wider range of use.
Can be used inside or outside
When you install your nails, you can change the direction of your nail, so you can change the outside/inner layer.
|
|
|
|
|
|---|---|---|---|
Can be changed between two and three claws.You can change the position of the nail as needed, and use it with 3 or 2 nails. |
Installation InstructionEasy to install and can be done by amateurs. |
Can be used inside or outsideWhen you install your nails, you can change the direction of your nail, so you can change the outside/inner layer. |
Carbon SteelCarbon steel mechanical puller, wider width, longer service life and not easy to break. |
