[red anodized]

[blue anodized]

[Chrome Plated]

[purple anatomite]

Product Description

This type is difficult to depend on the condition. Comes with a hood, so it is effective against dirt and dust, as well as rain. Increases intake efficiency and increases power.
Recommended air filter for normal carburetors.
● Dimensions are measured with the filter upright position, and the distance from the top of the filter to the bottom of the rubber pipe.
● Carburetor setting is required for installation.
Since the intake efficiency changes, a carburetor setting is required.
Please pay attention to the mounting angle. Installing the cover upside down may cause water to accumulate inside the cover and interfere with the intake.
When driving in rainy weather, water may enter the filter and the carburetor setting may change.
If the filter diameter is a few millimeters smaller than the carburetor caliber of your car, it will be slightly tighter when tightened, but you can install it by pushing it in.
If you install the long rear shock, the dilter may interfere with the body.

●About the 2000 exhaust regulation model
Since this model has a rare and thin exhaust regulation, there may be no settings on it, so we cannot recommend installing a power filter etc.

●About F1 car:
For F1 vehicles, please do not install a power filter or air funnel, as the fuel adjustment will be lost. However, if you install the fuel adjustment device (injection controller and Kitaka-made I-MAP) and you can set it up.

Legal Disclaimer

4990852511181