Feature(may vary by option.)

●Set Contents: 10 cleaning swabs for APS-C sensors (0.6 inch (16 mm)), cleaner + cleaning handle
●Upgraded Cleaning Power: 2.7 times stronger than older sensor cleaning swabs, providing a better cleaning experience
●Vacuum Packaging: Each vacuum packaging is individually vacuum sealed to keep it clean before use
●【MICROFIBER CARE】The cleaning wand tongue is wrapped with high quality microfiber cloth to effectively clean without leaving any residue or damage
●Innovative Handle: Grip with light and V-shaped design tongue + Velo width to match APS-C format sensor width

[APS-C size kit (with handle + cleaner)]




[Full size (swab only) 12 bottles]




[For APS-C size (swab only) 12 pieces]




[Cleaning pen]




[Full size kit (with cleaner + handle)]




[Cleaning kit]





Description

11
22
33
33
44

The handle extends to the tip of the cleaning swab for easy grip and makes cleaning sensors easy and effective.

It is equipped with a illumination light that allows you to check fine dust on the sensor for clearer and more thorough cleaning.

CR2032 batteries are used, low power consumption and long service life.

Cleaning handle makes cleaning the sensor easier and more thoroughly.

Operation Instructions

66

1.White background with f/11 or more smaller aperture, focus mode is set to manual, focus ring is infinity setting for shooting.

2. Inspect the details of the photographic images and enlarge the image to remember where dust is in.(Please note that the position of the small black spots on the picture is inverted to the position on the sensor. )

3.Remove the lens in a clean and bright place with anti-static gloves, adjust the camera cleanly and lift the reflector.

4.Use the air blower to blow out dust inside the body.

5. Remove the sensor swab from the vacuum packaging, swab foam on the cleaning surface of the sensor and then drag from one side to the other.

6. Use the clean side of the swab and repeat in the opposite direction.

7. If there is stubborn dirt, drop the sensor cleaner into the new sensor swab.

8. Use slightly wet sensor swab to clean the sensor again.

9. Use another new swab to remove the rest of the cleaner, then clean it again.

10.Put the lens immediately after cleaning, exit the camera from previous mode, take pictures as the previous one, and make sure the lens is clean.

Note:

Before cleaning the DSLR camera sensor, turn on the sensor cleaning mode and make sure the power is not running out during cleaning.For mirrorless cameras, please skip this procedure.

77

Warm Tips

1. Before cleaning the sensor, please make sure the camera battery maintains charging more than 80%

2. To avoid cross-contamination, each cleaning rod is best to use one time.

3. Before using the cleaning rod, please remove the large sand and dust from the sensor.

4. Do not directly apply the cleaner to the sensor or other equipment.