Used by professionals. Adhesive Y610 and Adhesive Reinforced Beads Set [Shaft Stretching Rod, Approx. 3 to 4 Times] [Shaft Replacement: Approx. 10 Times] Contents: Y610 A Agent, 0.4 oz (10 g) Container Excluding NET Sticky Reinforced Beads, 3 g Bag *How to Use/Precautions *1) Paint and Plating on the Adhesive Part You can file it with a sanding etc. Rough. 2) degrease the rough area. Part Cleaner is recommended 3) Mix an equal amount of A and B agent and once the color becomes gray, apply firmly to the adhesive surface and adhere to it. Estimated amount: Extension rod 1.0 inch adhesion 1.5 g - 2.0 g: 1.5 g - 2.0 g total 3 g - 4 g shaft adhesion 1 g : 1 g total 2 g 4) If the gap between the adhesive parts is large, use of spacers and glue strengthening beads. Estimated amount: 1 - 2 cups of ear pick After mixing, it starts to cure in about 3 to 5 minutes. (20 degrees Celsius) Higher temperatures and slower lower We recommend working indoors with air conditioners that adjust to the appropriate temperature. Especially in cold or hot days. The B agent will peel over time, so please use it as soon as possible. Light and heat will reduce the stability of the product, so please store in a cool and dark place. It is time to be used intensity, but we recommend 6 to 12 hours of experience. (Depending on the temperature) If the cap of a agent and B agent is wrong, the inlet may harden. B has a silver seal Please note that the container specifications and design may change without prior notice. Please read the product images and the information on the manufacturer website carefully before using. We recommend this product that has been used for many years and has been used for the manufacturing of golf clubs due to the adhesive strength and workability, but if you use it wrong it may not perform performance and cause a serious accident. Please be aware that any problems or defects involved in use are responsible for the purchaser. Hio-O-O