Feature

●■ This is for 200 series Hi-Ace 2WD.
●■ This is a value kit that includes 3 lowering blocks and bump stops.
●■ [Kit Contents] Lowering Block Kit 38mm, Bump Stop Set of 3
●For vehicles equipped with a III type discharge headlamp, and vehicles equipped with IV LED headlamp, please order with an auto-leveler adjustment kit.


Description

200 Series HiAce 2WD Low Down Kit 2 [1.5 inch (38 mm) + 3-Piece Bump Set]

Compatible vehicles: 200 series high ace/regias ace.
Year: H16.8-Current
Model: 1, 2, 3, 4, 5, 6
Grade:All Car
Body: Narrow body (standard body)/Wide body
Drive: 2WD

Description:
Compatible with 200 Series HiAce 2WD narrow body (standard body)/wide body.
This is a great value kit with lowering blocks 38mm (1.5") and 3 bump stops.

Please order the discharge headlamp and LED headlamp vehicles with auto leveler adjustment kit.

Kit Contents:
Lower Ring Block Kit 1.5 inches (38 mm) *Strength Test Results Included
Specially designed for 200 series with steel plated finish.
U-bolts are 13mm thick just like the original.
U-bolts are compatible with 0.9 - 3.0 inches (25 - 75 mm), so please cut off excess bolts before using.

(Bump Stops 3-Piece Set)
Front Low Profile Bump Stop:
Thermoplastic urethane resin (TPU) pad is used to create a thickness of 1.2 inches (30 mm).
There are 3 pieces of 0.2 inch (6 mm) thick plates, and it comes with an adjustable plate that can be adjusted to 4 different heights: 1.2 inches (30 mm), 1.4 inches (36 mm), 1.7 inches (42 mm), 1.9 inches (48 mm).
Genuine thick bump stop will always bump to touch when low down.
Low-profile replacement improves arm range and reduces uncomfortable bump touch.
Improves your ride

Rebound Stop:
Thermoplastic urethane resin (TPU) pads, 2.4 inches (60 mm) thick.
Prevents anchor arm play when torsion bar is loosen.
It also limits the range of motion with the upper arms on the extension side, reducing the roll (left and right swinging of the body).
You can cut it to change the height and adjust it according to the amount of lowdown.

Rear Thin Bump Stop:
Uses thermoplastic urethane resin (TPU) padex; thickness is 1.6 inches (40 mm).
Genuine thick bump stop will always bump to touch when low down.
Thin replacement ensures rear axle clearance and reduces uncomfortable bump touch.
In addition, the rear is assumed to have a bump touch depending on the amount of lowdown and load status.
Improved hardness, reduces impact when the bump touch is used, and improves the riding comfort.

Note:
Jastro vehicles have lower tire houses depending on the floor, and may not be able to drive due to the amount of down, tire size, and loading.
Please make sure to check the actual vehicle condition before making your decision.