4 LEDs turn on in sequence

Once detected, it will glow for about 15 seconds.Lights up continuously when people are in front of the sensor.

Precautions for Use:

1. Uses 3 batteries from the same manufacturer. 2. Since they are splash-proof construction, please be careful not to open the inside.

3. If dropped onto the floor surface during or after installation it may be dangerous and may cause damage.Be careful not to fall off the device when installing with tape or mounting screws.For outdoor installations, it is firmly fixed to prevent it from falling off due to the elements 4. Fallproof failure caused by falling. 5. If the sensor distance is shortened or darkened light, the battery will run out.6. Motion and CD sensors can not be adjusted and flashing intervals. 7. The sensor may malfunction or change sensitivity, depending on the usage environment. 8. When installing outdoors, please avoid using it in locations exposed to sunlight or where the car passes through.In this case, it is not a malfunction; 10. Replace the battery immediately if it does not light up due to the battery running out. 1. When not in use for a while, please remove the batteries and store them away.12. Do not use in high temperature or high vibrations where the device may break or stain the location of the device due to leakage.

Switch between lighting modes.

You can switch between the light mode only when the light is dark or the light mode can be turned on even when it is bright.

(You can choose with the switch on the inside)

If you choose the light only when it is dark, it will only light up when the sensor reacts to people in the darkness of less than 10 lux.

About Splash Proof

Splash proof specification equivalent to IP44 protection grade set by IEC.

What is IP44? Dustproof performance, protects from external solids of 0.04 inch (1.0 mm) in diameter, waterproof standards, and does not have harmful effects from splashing from any direction.

Main Specifications

Light source: 0.06W red x 4

Batteries: AA alkaline batteries x 3 (sold separately).

Battery life: 10 times per day (15 seconds per day) lights up for approximately 10 months.

Lighting conditions: Lights up at less than 10 lux in dark or brightly lit (select using internal switch).

Lighting Time: Approx. 15 seconds (fixed)

Accessories: Mounting screws x 1, wall resin ribs x 1, double-sided tape x 1.

1 Screw on the wall

For concrete walls, ceramic walls, and metal plates

1. Drill holes

2. Hammered resin ribs on the wall with a hammer

3. Screw wood screws with a screwdriver

Leave 0.2 - 0.1 inch (4.2 -

5. Hook on wall screws

2. Fix it to the glass or wall with double-sided tape.

Cannot be used on exterior walls or cross surfaces.

1. Clean off oil stains on the surface of the double-sided tape.

2. Stick one side of the double-sided tape to the mounting plate.

3. Put the sensor downward and stick it to glass surfaces.

4. After pasting, please use the double-sided tape for 1 to 2 days, so do not touch it.

3. Stick to iron surface with magnet.

Remove the mounting plate and attach the magnet to the iron surface.

4. Fix it with a band or string

Use commercially available magic bands or strings to attach to posts, stakes, or steel posts.