Overview / Applications:
The Lock Putty Build Up 60 is designed to be unshrinkable,
The carbon fiber blend is safe to use on high-tensile steel and ultra-high tensile steel plates.
Super thick polyester resin putty.
By 25% more carbon fiber formulation than previous products,
It is light, and is light, and it forms a strong hardening film.
In addition, the carbon fiber does not pill when putty, and has excellent abrasion.
Recommended as a successor to fiber putty kitty hair coarse and molding putty.
Please use 057-0063 or 057-0015 hardener.
Features:
It can be used with ultra-thick film thickness up to 0.8 inches (20 mm), making it ideal for reinforcing relatively deep recesses and cuts.
The non-shrinking design allows it to be used on high-tensile steel and ultra-high tensile steel.
By 25% more carbon fiber (compared to our company), you get a lightweight and strong hardening film.
Quick drying type with good adhesion, compatible with various rust resistant steel plates (automotive steel plates).
Can be forced to dry immediately after puttying (140°F / 60°C) or below.
In addition, 057-0015 lock polyputty hardener can be used when limited to heat drying.
Compatible Coatings:
Automotive steel plate (steel plate, rust proof steel, high tensile steel, ultra high tensile steel, aluminum alloy)
[Precautions]
The "automotive steel sheet" on the available paints are intended for domestic vehicles.
Adheres to rust-proof steel plates with high amount of zinc, and other non-ferrous metals such as aluminum materials
We recommend applying "wash primer" as surface adjustment to enhance the surface.
Please refer to the "Wash Primer" TDS for details on the wash primer
The main agent and curing agent is a weight ratio.
Before use, use the main agent should be mixed thoroughly from the bottom of the can, and then uniformly before using.
Also, because the hardener comes in a tube, you can loosen the cap and remove the air in the tube, then rub it.
Stir.
After use, wipe off the putty on the edge of the can, seal and store in a cool, dark place.
The putty on the edge may dry out and fall into the can, causing it to become too tight.
The hardening agent may break down or ignite due to heat, so please always store it in a cool, dark place below 86°F (30°C).
Please contact us.
Please strictly observe the heating temperature below 140°F (60°C).
057-0029 polyputty thinner solution is formulated with a range of 1-3% to the putty main agent and stir thoroughly.
Use it evenly before using.
Depending on the season, you may receive a quick drying type or a slow drying type, but please note that you cannot choose the type