Installation Instruction
1. Wipe the dirt and oil from the installation area with a wet cloth or wet tissue.If there is any leftover surface that may cause the panel to peel off after installation. Please wipe it carefully.Then use a dry cloth or paper tissue to absorb the remaining water from the attachment area.
2. Temporarily align the panels to the desired mounting position.
3. Peel off the protective seal of the double-sided tape.Peel from one end slowlyPlease check the adhesive strength of the tape by hand before peeling off.If the tape has low adhesion and it will need to be reinforced.
4. Remove all the protective seal of the tape and place it in the previously specified schedule.After installation, do not press the panel immediately, this stage is still fine adjustable.After finishing fine-tuning, use your thumb to hold the tape firmly where it belongs.Leave it for 24 hours at the end and it will stay in place.
[Caution] Please clean the grooves of the steering wheel before applying the ring.Although it is less likely to be slightly distorted due to shipping and transportation.In this case, you can restore the distorted ring by positioning the distorted ring in the groove of the handle and use the dryer to heat the distorted area and use your finger to shape the ring.Alternatively, it is one of the solution to affix the additional double-sided tape to only float areas due to distortion.