Feature
●Color: Black (QR is black); Compatible models: Rear wheel quick release hub; Compatible wheel diameter: 24 - 28 inches (700 C); Load capacity: 33.0 lbs (15 kg); External size: H 1.2 x W 1.6 x L 12.4 - 14.2 inches (30 x 40 x 315 - 360 mm); Main unit); Weight: Approx. 1 mm); Country of Origin: Taiwan
●3 major benefits of "Bike Guy QR Stand" Easy to put on and take off with just QR operation. (30 seconds after you get used to it, no tools required); You can even use bikes previously not equipped with a stand (disc brake, rear sus, deformation frame, etc.); Does not damage the frame! (You can rest assured that it will not leave marks on high end bikes and carbon frames)
●Revolutionary design that can be used in any shape of the rear end! You can adjust the direction of your nail freely, so you can use it on the road end and the positive end as well as the common straight drop (reverse nail) end
●Do not scratch the visible area of the frame. The only way the frame touches the outside face of the end where the QR housing is originally contacted, and the inside of the end opening where the hub axis touched. Even if you remove the stand, you will not see the marks at all. You can wear it with confidence on luxury bikes
●The leg length can be adjusted with a single Allen key and fits wheel diameter 24-28 inches (700C). Adjustment is required for the first time installation and no tools are required for the second time unless you change the tire or frame
Description
Attaches with a quick release (QR) on the rear wheel
Easy to install and remove with just QR operation.
No tools required and can be installed and removed in 30 seconds if you get used to it.
Disc brakes, rear suspension and deformation frames are OK.
Also, since the frame does not scratch, you can wear it with confidence.
From the Manufacturer
Installation Instruction
|
|
|
|
|
|---|---|---|---|
|
1. Put the stand and fixing parts through the included QR |
2. Pass the QR through the rear wheel hub, and insert the fixed parts into the frame end (there are no parts in the front for the convenience of shooting) |
3. The fixed parts will fit in the end opening as shown in the picture (Front part is removed for photo use). |
4 Adjust the angle so that the stand is perpendicular to the ground and insert the QR shaft deep |
|
|
|
|
|
|---|---|---|---|
|
5. Set the QR nut on the protruding QR shaft on the opposite side and tighten the QR tightly to secure it. |
6. Loosen the adjustment screw as needed and adjust the leg length to make sure the bottom touches parallel to the ground. |
|
|
Highlight!
|
|
|
|
|---|---|---|
|
The traditional load end has a positive opening, but the newly developed rotary stop parts can be turned to any point of the face. |
Can be firmly fixed on the load end! |
As seen from different angles |
