Feature

●Two buttons integrated presetter for quick operation
●Large LCD display for easy and clear results
●Presetter has a read resolution of 0.01mm / 0.0005in with high precision
●The mm/in button converts in or mm increments when power is on
●The measurement range is 0-2mm, and the height of its height is 50+-0.01mm

Description

Specifications: 1. Large screen LCD display, easy to read and understand.2. mm/in button: When the power is on, press this button lightly to switch between metric and imperial units.3. ON / OFF / ZERO: Short press this button to start, zero setting, and long press for about 3 seconds to shut down.Battery: SR44 1.5V button cell (sold separately) 5. Range: 0.2 inches (5 mm) Body Height: 2.0 + -0.01 mm Measurement Range: 0-2 mm 6. Read Resolution: 0.01 mm / 0.005 in 7. Repeat Accuracy: 0.01 mm / 0.005 in

MEASUREMENT INSTRUCTION: 1. Before use, tap the tool setting axis several times to make sure the slide is smooth.2. Wipe the bottom of the tool setter with magnet and wipe the surface of the zero setting base with a clean soft cotton cloth.3. Wipe the workbench or workpiece where the distance to the tool tip needs to be determined.4. Put the tool setter upside down on the workbench or flat surface, slowly press down to ensure zero setting base and workbench is fully attached, then press ON / OFF / ZERO key to set zero position (as shown in Figure 1).

5. After zero setting is completed, set the tool setter in the workbench located just below the tip of the machine tool (see Figure 2), slowly move down until the tip touches the surface of the tool set shaft, and follow the next step.Slowly adjust.until the LCD display readings reach 0.00mm (see Figure 3).At this time, the distance between the tip of the tool and the workbench is 50 + 0.01 mm.At this point, set the Z-axis to zero before moving the device to a safe distance.Remove the toolsetter and move the Z-axis down.Move to the previous zero position.At this time, the distance from the tool tip to the workbench is 50+-0.01mm.Tool tip to workbench to complete tool settings according to your actual needs.

Notice:1.Spray a large amount of cutting fluid directly onto the surface of the tool setter is strictly prohibited.2. The impact is prohibited.3. Do not drop the accuracy of the toolsetter and avoid damage to the tool.