Bearing separators 75-105mm are used on the base when removing bearings with hydraulic press.
Ideal for pulling bearing bearing bearing into car or motorcycle shaft.
[Range of use] 3.0 - 4.1 inches (75 - 105 mm)
[Mounting Hole Diameter] M12 x 1.5 *This product is not used when used as a stationary stand for press.
[Material] Chrome molybdenum steel
■ Between the bearing and crank, insert the plate from both sides and tighten the bolt nut.
■ If the nails of the main unit do not fit completely, tighten the two bolts evenly and spread the gap between them.
■ If pressure is high or tight, it is recommended that you use heating or lubricating oil, etc., without trying to pull out the force.
■Forged and hardened
[Warning] Cannot be used with bearing puller set (part number 19-600).