All stainless steel construction, high strength, high rigidity wheel puller. Also compatible with 35mm super large diameters. In addition, the rims of the wheel are made using a board to draw out the wheels, making it portable and evenly weighted for compact storage. The top of the T-shaped swivel handle has a M2 screw hole, so you can set the handle at your desired length like a press inserter. With a force, it can be pulled on the underside, so you will be able to pull the surface such as the rims of the wheel, so you can apply the force to draw evenly and straighten it out. The screws are also made a little thicker and the fit is reduced to rattle. As a result, the screw part can be used to protect a variety of surfaces. Also, you can "chamfer" the tip of the pin and press the center into the hole of the hollow shaft. The tip is also flat so you can press it on the face other than the hollow shaft, and it is tapered so it is easy to insert into the axis and holes. Product Overview: Material: Screws, Block Part: SUS303, Plate Part: Spring Steel SUS304CSP 3/4H 0.03 in (0.8 mm) Processing Method: Arm Part: 0.03 in (0.8 mm) Laser Cut, Bar, Screw, Handle: Lathe Shaving, [Caution] We cannot accept returns or exchanges for products other than defects such as chipping or distortion. There may be some cutting oil or other adhesion, but you can use it without issue. The screws and screw holes are made of hard materials, and it is recommended to be used with oil or grease attached for protection. Please be aware that we will not be responsible for damage caused by using jigs.