For soldering

Soldering iron tip unit:

Maximum Temperature: Approx. 104°F (420°C).

Continuous Usage Time: Approx. 45 minutes.

For cutting styrofoam

Heater unit (short)

Maximum Temperature: Approx. 78°F (300°C).

Cuttable thickness: Maximum approx. 1.6 inches (40 mm)

Continuous Usage Time: Approx. 25 minutes.

Heater unit (long)

Maximum Temperature: Approx. 482°F (290°C).

Cutting thickness: Maximum approx. 2.4 inches (60 mm)

Continuous Usage Time: Approx. 25 minutes.

PACKAGES

Soldering iron & styrene cutter main unit x 1, soldering iron tip unit x 1, heater unit (short) x 1, heater unit (long) x 1, protective cap (installed at the time of shipping) x 1, USB cable x 1, storage case x 1, instruction manual x 1.

Storage Case

Comes with a convenient case for storage and transport.

USB Rechargeable

Charging time (estimate): Up to 3 hours (empty to full charge).

Charging Lamp Indicator

Point light (red) → Charging point light (green) → Charging complete

Installation and removal of tip parts.

Simply screw the tip cover in the direction of loosening the cover.Please screw the included tip parts into the mounting part of the tip part to suit your needs.Rotate the tip cover in the direction of tightening to secure it as original

Switch Operation

Press the I (ON) side → power on and the power lamp will light up.Press the O (OFF) side to turn off the power and the power lamp turns off.

Once the power lamp is lit up, the soldering iron will be approximately 25 seconds, then the Styrol Cutter will be usable temperature after about 10 seconds.