Transfer temperature: 150℃/305℉
Hours: 12-15 seconds
Protection Film: Yes
Iron-on Print Sheet Care Instructions:
1. The design must be inverted (mirrored image) and cut from the back (glue)
2. Once the cut is completed, remove the unnecessary parts (scumbers) that are not sticked.
3. Turn the transparent PET sheet inside out when the debris is completed.
4.Iron over PET sheet.
How to apply the iron print sheets:
Work 1 Positioning
Place it on the surface.
Please avoid any deviations in the folded area, fabric seams, etc.
Work 2: Paste
Press with an iron on the top. Application temperature varies by sheet type.
If you slide it around the surface, it may cause misalignment, so you can press the entire surface while changing the position. (If you use a steam iron, the steam spout will not hold down, so please often change the location. )
Work 3: Peel off the transparent PET sheet.
Let cool a little heat, then peel off the clear PET sheet.
If the iron print sheet is pulled on the transparent PET sheet and it seems to peel off, it is not sufficient, so please iron it again.
Work 4 Confirmation
After completing this press, let it cool and check if there is no crimping shortage.
If there is a lack of crimping, please press it again with a press cloth.
When crimped tight, you are done.
You can use it not only for clothes, but also for cloth tote bags or anything you like.
Important Notes:
1. Do not iron the iron sheet directly.
2. If ironing is required, please use a press cloth.
3. If you do not know the temperature setting of your iron, try using a cutting edge.
4. We cannot be responsible for any mistakes or damage due to installation etc.
5. Crimp with a hard base.