Feature

●Connects to 10mm wide RGB 5050 LED tape with one touch
●This connector can connect two RGB 5050 LED strips. Easy Connection, No Soldering
●Flexible and Durable: Each cable is composed of 4 individual wires, the cable can be bent and twisted at any angle
●Cable Length: 5.9 inches (15 cm); Total Length: 6.7 inches (17 cm)
●Contents: 10x One-Touch Connecting Connector Cable


Description

10mm Wide 4 Pin SMD 5050 RGB LED Strip Light Connector

Installation Instructions:
1. Make sure your LED tape is RGB 5050 LED tape with 4 contacts (+, B, R, G).
2. Open the white connector of the 4-pin connector cable.
3.If the RGB 5050 LED tape is not waterproof, just insert the LED tape into the connector. The 4 copper contacts of the LED tape must be under the four prongs of the connector. Please connect the "+" and "-" electrode correctly.
If the RGB 5050 LED tape is waterproof, you need to peel off the PCB board silicone around the cutting line and insert the LED tape into the connector. The 4 copper contacts of the LED tape must be under the four prongs of the connector. Please connect the "+" and "-" electrode correctly.
4.Close the connector.
5. Pull the LED tape firmly to ensure it is connected.

Note:
After inserting the LED strip light into the connector, before closing the connector cap, please pull the LED strip light lightly to adjust the connection point until the LED lights up. If the LED does not light up, press a bit hard on the connector 4 metal contacts until the LED lights up with your finger. Loose connections will reduce conductivity, and the LEDs will flicker or color conflict. Loose connections will reduce conductivity, and the LEDs will flicker or color conflict.

Package Includes:
10x One-touch Connecting Connector Cable