How to use the machine:
1.Modified
The connecting belt is secured to the groove under the aluminum fixture (usually V, O grooves) (clamp main refers to the gasket and nut).Specifically, remove the nut on both sides of the nut and nut (if the belt can be inserted directly into the groove depending on the diameter of the belt, do not remove the nut and gasket), insert the belt into the groove.Nuts relocked parallel to the groove above the side of the gasket plywood are appropriately spaced about 0.8 inch (2 cm) (can be placed in the middle of the thermostat heater).
Chip:
PU round with small diameter of the polyurethane belt and round belt on the top of the tank, align the round belt 2 connector, then place the bottom if the diameter of the round belt or red polyurethane ribbon is large.Inside the groove! The
2.Heating
Constant temperature heater (maximum temperature of belt connection 160 - 180 degrees), fixing belt heating (assuming a heat belt should not be bubble, otherwise affects the connection effect), then docking.Tighten the clamp manual clamp nut to the belt docking company.
3.Re-treatment
After the belt docking is completed, removing the belt and leveling, it will completely cool.