Connect one side connector to a 8mm wide single color LED strip light (single color 3528/2835) The other side can be connected to the DC plug of the adapter.
Allows you to connect the cut portion of the tape light without soldering
Open the cover of the connecting connector to reveal a single color double core contact.
Insert the conductive surface of the connected tape light into contact with the contact.
Tape is connected when the cover is closed.
Installation Instruction
1. Make sure the width of the LED strip is 8mm and there are 2 copper contacts on the cutting line.
2. Carefully cut the LED strip along the cutting line. Do not tear the paper on the back of the LED strip before completing the connection. Insert the paper and LED strip together into the connector. This makes it easy to insert the LED strip into the connector without bending and breaking it and also makes the connection stable.
3.Open connector cap
4. If you want to use non-waterproof LED strip, please insert the LED strip into the connector. Make sure the two copper contacts on the LED strip are under the two conductors of the connector;
After using the waterproof LED strip, first remove the waterproof silicone around the cutting line, then insert the LED strip into the connector. Make sure the two copper contacts on the LED strip are under the two conductors of the connector.
5. Close the cap and make sure the connector works normally.
6. Peel off the paper on the back of the LED strip and stick the LED strip, but please take the paper already in the connector.
Note
Make sure the positive pole of the LED strip on both ends of the connector is on one channel of the same Make sure your cables, LED strips, and controller arrow marks are on the same channel.
Solutions
If the LED strip flicker or doesnt light up, please follow these steps:
1. Remove the LED strip from the connector.
2. Open all connector caps
3. Use a thin and hard object to press both ends of each conductor in the connector simultaneously to lower the conductor to its lowest position. At this time, make sure the conductor touches the surface of the connector without pressure. In this way, the two conductors of the connector come in contact with two copper contacts on the LED strips, ensuring good conductivity.
4. Insert the LED strip into the connector.
Package Includes:
10x Solid Color SMD 3528 or 2835 LED Strip Light DC Jack One Touch Connector