[Single Item]

Product Description

Cleaner for clear resin parts such as headlights, turn signals and tail lights.
A 2-part finish type with a base cleaner that removes yellowing and grains and a "hardtop coat" that exhibits gloss and prevents deterioration caused by dirt and UV rays.
Just polish and paint to ensure high clarity for a long time.
Includes a dedicated sponge and cloth.
Product Usage
1. If your body has sand or dust build, please rinse it off and wipe it off before use.
2. Shake the base cleaner well and apply the liquid to the dedicated cloth to polish while ensuring that the yellowing and grains disappear.
If there is deep scratches, dirt inside the lens or resin itself is discoloration, it will not be effective.
Please be careful not to polish too much.
3. When you finish polishing, wipe it gently with the clean surface of the special cloth.
4. Shake the hard top coat well and apply a thin amount of soaking into the cloth surface of the dedicated sponge.
Please do not use if the liquid is white and cured in a jelly.
Please do not use a special sponge that has been used once.
5. After drying for 1 minute, use the opposite fabric surface of the dedicated sponge to make the paint mark less noticeable.
The film will cure completely in 3 to 4 days. Also, please do not touch or get wet for 24 hours after installation.
The hard top coat before curing is soft 99 "silicone off" (sold separately) and can be removed with a base cleaner.
Precautions for Use:
Do not use for anything other than its intended purpose.
Do not use on areas where visibility is problem, such as helmet shields or motorcycle cowls, or car navigation systems.
Do not rub or get wet while drying.
The liquid reacts with the moisture in the air, so you can close the cap immediately after use, and use it immediately.
Do not use in hot or rainy weather or when the temperature is below 20°F (10°C).
Make sure to use the included sponge
Wash your hands well with soap, after use.
[Warnings/General Warning]
Cannot be used for inhaling or drinking: This product is harmful to the human body, so please do not inhale or drink.
Please use protective gloves as people with weak skin may cause rash.
Flammable, so keep away from fire.
Please keep out of reach of children.

Ingredients

Silicone-based compounds, alcohol

From the Manufacturer

Removes yellowing and fogging

Shake the base cleaner well and apply an appropriate amount of liquid to the dedicated cloth, and polish while confirming that the yellow tone and grains disappear.

If there is deep scratches, dirt inside the lens, or the resin itself has been discoloration, it will not be effective.

When you finish polishing, gently wipe off the clean surface with the special cloth.

Contains abrasive material, so be careful not to polish too much.

Gloss and stain release

Shake the hard top coat well and apply the appropriate amount to the cloth surface of the dedicated sponge, then spread it out.

Do not use if the liquid is white and cured in a jelly.

Cannot be used with a dedicated sponge once used.

After drying for about 1 minute, use the opposite fabric surface of the dedicated sponge to make the paint mark less noticeable.

The film is fully cured in 3 to 4 days, so it should not touch or get wet for 24 hours after installation.

The hard top coat before curing can be removed with a soft 99 "silicone off" (sold separately), and after cured it can be removed with a base cleaner.

The transparent shine is restored.

Eliminates yellowing and tarnishing headlights that are worried about old cars over time.

Durability for approximately 6 months (based on our test).

Can be used in such places

In addition to headlights, it can also be used for clear resin parts, such as turn signals, tail lights, visors, etc.