[8.5mm]

[2.5mm]

Product Description

Impact screwdriver allows you to drill holes in mortar, block, plaster, and board.

[Use]
For drilling holes in mortar, blocks, gypsum boards, etc.

Features:
The cutting blade uses a carbide tip with excellent hardness and abrasion resistance, allowing for high precision drilling speed.
The 0.25 inch (6.35 mm) hexagonal shaft allows it to be attached to an impact driver with one touch.

[Precautions]
Since this is a blade made specifically for rotation, it cannot be drilled into concrete.
Please use each drill blade for concrete / porcelain tile, stone, enamel, and metal.
Before installing the blade, please check the blade as there is a risk of injury if there is cracks or injuries.
Please be sure to test before work.
Please check for the drill blade to ensure there is no shake and then chuck again.
Please do not work near flammable liquids and gas as there is a risk of fire or burns.
Please make sure that the holes are clearly visible in a wide area.
Please keep your hands away from the drill while working.
Please do not point the blade to people around you.
The drill immediately after drilling will become hot and may cause burns, so please do not touch it with bare hands.
Please hold the electric drill firmly during the hole and be careful not to shake it around.
Ensure the scaffold firmly during the perforation, and be careful not to ruin your posture when the hole is overheated.
Please connect the double-insulated electric motor to the installed power supply for complete prevention.
When working, please be sure to wear dust-proof glasses and dust mask to ensure safe operation.
Remove the drill blade from the main body and clean thoroughly.
Please store in a safe and dry place.

Amazon.com Review

●モルタル·ブロック·石膏ボードへの穴あけに