[Uses] Re-stick shoji paper [Features] ·Plastic is bonded between shoji paper that is resistant to tearing, and is resistant to pet scratches. ● Increases heating and cooling effect (compared to breathable shoji paper); UV protection prevents fading in the interior of the room, and discoloration of the shoji paper has a traditional texture, odorless type that does not have an unpleasant odor, and can be finished with 1 coat

[Caution] *Does not adhere to aluminum or plastic shoji frames. Please do not use an iron that causes abnormal high temperatures as the temperature will not be adjusted. The paper may deteriorate. This is a commercially available backbone agent and when you remove the old shoji paper, please thoroughly hydrate it. If there is a peeling agent left on the pier, the adhesive may be rubbed. If the frame of the shoji is uneven, please lay flat with sandpaper (around 200 numbers) and remove the scraper before sticking. There may be cases where the shoji frame may not adhere well to certain special shoji frames. If the shoji piers fall off or break, please repair them in advance with a woodworking bond. Please do not iron too much in the same place. If it does not stick properly, please lay down the pier once before gluing. After finishing, if wrinkles or talumi appear, please make sure that the shoji paper is glued to the pier, and iron it lightly to touch the part or dilute water from both sides and spray evenly with water. This product is made of plastic, so it may be condensed. If condensation is severe on the product, the adhesive may rub off. Please perform work with good ventilation. After finishing, wash your hands with water and clean with cream. Do not use for anything other than shoji paste purposes. Installation Instructions: This product has the adhesive surface on the outside. Iron on high temperature (dry). Please dry the shoji frame thoroughly before sticking. (1) Determine the position of the shoji paper, then iron the upper bar and temporarily stop 1 location in front. (2) Spread the paper parallel to the front of the shoji and cut the desired length. (3) Move the iron to the whole dock from the center to the surroundings.Keep it parallel to the pier, and iron the corners to prevent tarumi. (4) Use an iron to glue the surroundings. (5) Place the cutting ruler and trim excess paper with a utility knife. Slowly iron once again Please attach firmly to the surroundings. Please store any excess shoji paper. You can paste it over the top with shoji glue, so please use it for spot repairs. If there is a partial peel after ironing, please repair it with a shoji glue.