Compatible models: For Jimney JB64 (Part Number: 7109-64).
It is relatively easy to put on and install. A Phillips screwdriver (#2) is required to increase or tighten the factory mirror.
Product Description:
This is a blue-wide mirror that can be attached to a genuine Jimney rearview mirror.
The back is also fully covered, so it has a great tightening effect when viewed from outside the vehicle. The back cover features an appio inspired black body with a black logo. It is a subtle statement.
The mirror body uses a blue mirror. Significantly cuts the glare of the headlight on the following cars. It has a high anti-glare effect that helps to ensure a blurred and clear vision in strong light.
This is a loose-curved mirror cut from a 3,000 mm radius sphere. As with a typical curved mirror, if the mirrors curvature is larger (such as 1400SR), it can be used to create a wide range of images, but on the other hand, the image will be smaller than the actual image. So you can feel further than the actual distance. Therefore, this product is set to 3000SR, a curvature that is balanced between a wide field of vision and a natural sense of distance. It can reflect a wider range than a flat mirror on a genuine rearview mirror, so the field of view is expanded to a maximum of about 1.6-1.7 times compared to the original rearview mirror. The mirror is cut from a uniform spherical surface, so you can create clear images without distortion.
Designed specifically for the vehicle
This product is for Jimney JB64 and Jimney Sierra JB74 in different shapes. The Jimnie Sierra JB74 features a genuine mirror with anti-glare lever, which is shaped to avoid the laser on the cover side. The Jimney JB64 has no cut out design. Please be careful not to make a mistake when making your purchase. It is designed specifically for the vehicle, so it can be used without interfering with the visor.
Note:
·This product cannot be used with other rearview mirror parts or accessories.
·This product is a loose-curved mirror, so there may be differences in visibility and distance from the genuine rearview mirror.
When installing this product, a Phillips screwdriver (#2) is required to tighten the original mirror.