|
|
|
---|---|---|
STEP1 CleaningCarefully remove the dirt from the mounting part of the visor with the included degreasing cotton. |
STEP2 Remove RubberPull slowly off the top part of the window rubber frame (ram channel). |
STEP3 Fastener InstallationBrackets may vary between front and rear use.Preparedness comes with a protective seal or protective rubber cap, so please remove it before attaching the clasp! |
|
|
|
---|---|---|
STEP4 Double Sided Tape PreparationPeel off the blue protective tape from the double sided tape of the visor.The protective tape should be removed upwards so that it can be pulled during installation. |
STEP5 Temporary MountingInsert the visor fastener into the window frame and replace the rubber frame. |
STEP6 AdhesiveOnce the installation is done with the fastener, pull all the protective tape off and apply the double-sided tape to adhesive. |
|
|
|
---|---|---|
STEP7 Final FixedThe tape will adhere firmly when you slide it with a towel or the other while holding it down. |
STEP8 CompleteNo tools required and can be installed by a single person in about 30 minutes to 1 hour.Done! |
Package ContentIn addition to the side visor, the fasteners, cotton degreasing, and instruction manual are also included.(There may be cases where the front is only used in some vehicles such as light truckers. ) |