■ Flywheel puller *As it is an imported product, it is not good in finish. ■ Weight: Approx. 3.3 oz (1,050 g). ■ Size: Center Shaft Size: M16-1.5 Total Length: Approx. 3.7 inches (94 mm). Effective Working Length: 1.6 inches (40 mm). Compatible with holes between 2.2 inches (55 mm) to 3.3 inches (85 mm). *Please see the images for details. ■ Please use bolts that match the size of the service hole. Most often fit long bolts used for case covers. ■ Can be installed and used up to the [M8] bolt. ■ This puller is compatible with 2 and 3 hole service holes. ■ For removing magnetic wheels. ■ As a crankcase separator. ■ Replaces Harmonic Balancer Puller ■ Please be aware that we will not be able to respond to the suitability of the vehicle or the suitability.
Multiple vendors are sold separately. Products shipped from Tools Direct Co., Ltd. are as pictured, but we cannot be sure that the products shipped from other stores are the same. Please make sure to check the "distributor" and "shipping" before purchase. *Due to the imported goods, there may be slight differences in size, minor scratches, and dirt etc. Please refrain from purchasing if you are looking for quality products or concerned about the condition and quality of the product. We will refuse returns and exchanges due to reasons such as the size of the product that is not suitable for use. Please check the product details before placing your order. Because this is a cheap imported product, returns and exchanges cannot be accepted. Please note: We will not accept any returns for defects due to usage laws that are not used in regular usage, or liability for injuries or damages. Thank you for your understanding. After you place your order, we will confirm that you are aware of it