Simply pour it into the radiator and stop the leaks with the holes and cracks.
Can also be used as a preventative agent.
How to Use:
STEP1
Always stop the engine and make sure the radiator is cold.
For older radiators, use a radiator cleaning agent to remove rust and dirt before injecting them.
STEP2
Shake the bottle well and open the radiator cap to fill the liquid.
For cars with the amount of cooling water below 3.9 gal (10 L) of water is less than 1 product, and 2 cars with 2.2 gal (10 L) and above.
Smaller capacity radiators require less amounts
In cold weather, it is easy to pour by heating this product with warm water.
STEP3
Replenish coolant water as required
Close the radiator cap and turn on the engine to circulate coolant water. Make sure the liquid is stopped.
Cannot be treated for damage over 0.05 inch (1.2 mm) in diameter.
This product is an emergency procedure, so please make sure to repair or replace the radiator after use.
Cannot be used on the following vehicles: (Please check with your car dealer if you are not sure.)
Side flow radiator car
Cars with cooling water passages inside the carburetor (twin cab, etc.)
Car with coolant water filter (strainer)