[Type 1C2/RE] Fuel Fuel Cap Cover [Aluminum Red and Anodized Finish] <220 Crown Logo Mark Cutting Sticker / General Purpose Product / Customer Order> European Specs / Braga [Compatible Models] General Purpose Product *Some models, years and grades may not be able to fit different shapes. Please make sure to check the following fitting examples and fitting sizes before making your purchase. Can be attached to gasoline cars (both high oku and regular use) as well as diesel cars (air oil). This product is only for genuine caps with a drop prevention cord on the side. Therefore, it cannot be attached to a cap that has a drop prevention cord on the top of the cap or without a cord. Crown [CROWN] Turbo/Hybrid/Athlete/Royal Compatible, 220/20 Series Crown, 200 Series Crown, 210 Series Crown, Other Crown Majesta, Majesta, 200 Series Majesta, Other Majesta, Product Color / Red [RED] Anodized Finish; Product Material: Aluminum. Made Shaved ■Each size of this product *Please refer to the diagram for each size of this product External Size: Approx. Diameter 2.7 inches (69 mm) x Height 0.9 inches (23 mm); Internal Size: Approx. Diameter 2.6 inches (65 mm) x Height 0.7 inches (17 mm); Opening and closing knob interior: Width 2.6 inches (65 mm) x Height 0.6 inches (16 mm) x Height 0.7 inches (17 mm). Note: Note: The external size of your original oil cap can be installed on the product inside size. Please make sure you do not mind before [Compatible sizes with genuine oiler caps] *Please refer to the following [Examples of compatible crown genuine oil cap / compatible sizes] External size: Approximately within diameter 2.6 inches (65 mm) x height within 0.8 inches (20 mm); Opening and closing knob size: within width 2.6 inches (65 mm) x height within 0.7 inches (17 mm) (within the middle part) within 0.7 inches (17 mm); Note: This product is an overseas import, there may be some uneven finishing, small scratches, dirt, burround, dirt, dust or bleed double-sided tape. Please acknowledge This product is a generic item only. It does not cover all. Therefore, there may be slight gaps, etc. visible around the mounting part. Please acknowledge Installation is done on a wide flat surface other than the road. Be sure to stop the engine and turn on the handbrake before doing it. Then open the oil inlet door.