[Built-in antenna V2 SBUS]

This is the DASMIKRO FUTABA T-FHSS Internal Antenna for SBUS Version 2.

Compared to version 1, Version 2 has the following changes:
1. SBUS output available
2. Change the position of "Signal" and "GND" Futaba and Tamiya connectors eliminate the need to change the cable position.

Compatibility:
Futaba 10PX
Futaba 7PXR
Futaba 7PX
Futaba 4PX
Futaba 7XC
Futaba 4GRS
Futaba 4PV
Futaba 4PM
Futaba 4PLS
Futaba 3PV


Compatible with Futaba T-FHSS vehicles. Provides 4-channel full support.
High performance CPU for enhanced precision control, fail-safe function, and ideal for Micro RC racing chassis.


Specifications:

1. Channel: 4 channels
2. Operating voltage: 3.7V-8.4V DC
3. Weight: 5g
4. Size: 25.5mm * 22mm * 17.3mm
5. Antenna: Built-in


Pairing Method:

Please refer to the 4th picture
1: Turn on the transmitter and switch to link mode.
Second: Connect the binding cable to "BIND" for about 2-3 seconds, then remove the binding cable as shown in the 5th picture. (LED starts flashing red)
3: After the receiver LED switched from red flashing to green, the transmitter and receiver are linked normally, please turn the power off and turn it on again, if the receiver LED is lit green, the pairing is successful. Check the servo in real life.

Package Includes:
Receiver V2x 1
1 x Binding Cable


Normal mode / Fast mode:
"Normal mode" accepts all servos or peripherals.
"High Speed mode" only accepts digital servos including the BLS series and most peripherals such as brushless ESCs. For a comfortable driving experience, please pay special attention to the information contained in the transmitter manual