Feature

●EVERY DA17V SUSTEC Underbrace Rear Floor Support / Member Support
●The recommended retail price shows the shipping cost. The vehicle installed photo is an image after installation
●Grade PA Limited RBS Vehicles from May 2017 - HBD-DA17V R06A
●EVERY DA17V SUSTEC Underbrace


Description

Installation location: Rear 2 point stops; Vehicle height data (with standard vehicles); Front 24.0 inches (619 mm); Rear 24.4 inches (624 mm); Under brace ground height without underbrace: Oil pan guard; Under brace: Oil pan guard; 5.2 inches (157 mm); Clearance data: Approximately 0.4 inches (10 mm) (658 mm). Please check the product image This is a representative car model, not all cars are the same shape. 2 or 4 points depending on the vehicle. ·There may be cases where the ground height is not possible by installing this product. Please check the minimum ground height and car height before installation. Depending on the vehicle, the minimum ground height of the vehicle itself is the lowest part of the vehicle. For that reason, please be careful of the mounting suspension to maintain a minimum of 3.5 inches (90 mm) above ground height required for safety standards and inspection guidelines. The same is normal suspension and our suspension vehicles. Vehicle inspections and periodic inspections must be met with the aforementioned, but only the user of the vehicle must include the responsibility of maintenance management. The load clearance will be reduced after installation, so please be careful when driving. Each measurement measurement is based on our companys measurement conditions. Please use this product as a reference as it may differ depending on the model and vehicle conditions. ·Please note that the minimum ground height data is the near dator with an underbrace attachment, and is not measured throughout the vehicle. Please note that installing this product may cause difficulty in replacing engine oil, mission oil, etc.