[5 meters]
[50 meters]
Step 1: Clean and dry the surface of the car to be installed. Apply the tape to the desired part of the film to cut. Step2: Apply firm pressure to the tape to make the start and end tape visible. Point: If you leave the holding part about 3.9 inches (10 cm) at the start part, it will be easier to cut the film. To remove air bubbles, press the film with your fingers again to press it onto the cutting tape. Step3: Take the filament in your hand, then pull it off to the edge of the film, then fold the filament. Step4: Press the thumb on both ends of the filament and the film edge. Gently pull the filament to start cutting into the film and pulling straight out is a point. Step5: After cutting, remove the excess film and carrier tape from the bottom of the film. Forget about the carrier tape will cause a step in the film. Step6: Apply firm pressure on the edge of the film and reapply it to finish it. You can expect it to increase the adhesion by applying a little heat.