When loading staples

Point the bottom of the main unit upward.Hold both sides of the magazine lock button simultaneously (1) and pull the magazine base back out.(2) Put the staples upward and insert them in the magazine.(3) Slide the magazine base forward until you hear a "click" sound.

Please be careful not to pinch your fingers.

When loading T-shaped nails.

Point the bottom of the main unit upward.Hold both sides of the magazine lock button simultaneously (1) and pull the magazine base back out.(2) Put the foot of the T-shaped nail upward and put it in the magazine.(3) The T-type nail is placed in the front of the main unit or on the side with the magazine base.At this time, tilt the body slightly and let the T-shaped nail stand on the side of the magazine.Slide the magazine base forward until you hear a "click" sound.

Please be careful not to pinch your fingers.

The thickness of the wood that can fix T-shaped nails (0.4 inch (10 mm)), is up to 0.1 inch (3 mm).Please note that if used on wood over 0.1 inch (3 mm), it may not be firmly fixed.

How to hammer staples T-shaped nails?

Push the contact arm vertically to the workpiece.(1) Pull the switch trigger while holding the top of the main unit with one hand.(2)

In order to prevent the contact arm from floating, please hold the unit firmly and pull the trigger on the switch.

Check remaining capacity of staples and T-shaped nails.

You can check the remaining amount of staples and T-shaped nails from the staple check window.

The staples can be checked from either the left or right, but you can only check the T-shaped nail from the side with the T-mark.