This listing is for a set of head parts for decorative spring hooks and a plastic plate for each size and shape.
Material: Punching Rod: Iron (with plating) Plastic Plate: Polypropylene
Quantity: 2 x knitting rods (uneven set), 1 x plastic plate
When installing a decorative spring hook: Other tools are required to attach a flat steel base, hole punch (hole diameter 0.1 inch (3 mm)), mallet is required.
If you install the brass spring hook head diameter 0.5 inch (12 mm), please use a 0.5 inch (12 mm) plate with a 7 inch (12 mm) base. (You can use the hammer rod)
It is sized to fit the decorative spring hooks we sell, so it can only be used with spring hooks in shop.
The head of the decorative spring hook and the spring part have a round tip, so it will not fall into the double line springs on the female side, but it opens and closes as a spring attribute, so if you apply a little force, it will fit.
(The same principle of opening and closing between the spring and dowel of the spring hook)
[Quality & Support] We will do our best to the end, so if you have any problems such as lack, defective or insufficient information, please contact us by email. We will try to make the correct response, but we will resend or refund as much as possible.