Invisible Dive Case

Show the mystery of the water

Seamless underwater photography

Thanks to the special dome construction, 360 degree shots are perfectly stitched. Case corrects water refraction and eliminates distortion and stitching problems.

Dive deeper

The exclusive sealed structure makes this invisible submersible case IPX8 waterproof, allowing you to shoot underwater up to 164.4 ft (50 m).

Finished official accessory after the development of trial and error.

Insta360 Development Team is developed and manufactured exclusively in house to protect the X3 perfectly. Rigorous testing.

How to use

Open the case Lift the buckle as shown in the picture below (1) and pull down to release from the hook (2)The other three buckles do the same, and open the dive case. Install the anti-fog sheet. Make sure the anti-fog sheet is inserted as the picture below. Note: If you use other manufacturers anti-fog inserts, please make sure the size is within 37.1*16.0*1.2mm.If the insert is too large, it will leak and damage the camera. Insert Camera Note: 1. Please update the camera firmware to the latest version before using. 2. Before inserting the camera, you need to activate the submersible case mode. Swipe down the cameras touchscreen to open the shortcut menu, tap the icon, and select "2023" to enter the submersible case mode.When you enter the submersible case mode, press the power button to switch shooting mode, and press the Q button to start or stop shooting.For more information, please refer to the "Button Instructions in Dive Case Mode" in the user manual. 3. Before inserting the camera, please make sure the camera lens and dive case interior is clean and free of dirt and dust. 4. When inserting the camera, please remove the pre-installed lens protection filter and avoid damaging the lens. .Close the case To close the submersible case, hang the buckle on the claws of the case and push it firmly until it clicks. Note: 1.Make sure the dive case is securely closed.Ensure there is no dust or dust in the area that touches the rubber gasket of the dive case 2. For best results, keep the submersible case lens clean. .Install the stabilizer ring.(if needed) When connecting other accessories such as a dive case and floating hand grip, the mount adapter will be more secure and can be attached to the screw to prevent looseness of the accessory or sand caused by camera vibration. Stitching to ensure that both lenses are not facing the surface of the water for best results.After shooting, open the file in the Insta360 app or Studio and it will automatically be selected for stitching for invisible dive cases.