Feature(may vary by option.)
●New Version: Compared to the previous version of the NanoVNA, we introduced a new ABS case and a new package to minimize issues caused by impacts during transportation. Support Time Area Analysis Function (TDR)
●USB-C to USB-C: Support USB-C to USB-C line, more convenient to connect your phone. Compatible with most android phones with the same screen (Not compatible with iPhone) Solve the problem of small screen and lack of brightness. It can also display the amount of battery used on the interface
●Wide Frequency Range: Improved frequency algorithm, si5351 odd multiplex extension function supports measuring frequencies up to 1.5GHz. The si5351 direct output provides a dynamic range of over 70dB in 50K-300MHz bandwidth and over 40dB in frequency bands
●Simple and practical PC control software. You can export the touch screen (snp) files via PC software, so it can be used with a variety of wireless design and simulation software
●By leveraging Spectra Premiums expertise in OE engine management system design, we have achieved our requirements. Platinum connector threads reduce the number of connection points and faster response to change. Ceramic printed circuit board is protected by silica gel, excellent resistance to temperature changes and vehicle vibration
[Nanovna-H]
[Nanovna-H4]
Description
Description
New Improved Version 3.6 Vector Network Antenna Tester 10KHz-1.5GHz MF HF VHF UHF with Shell
ABS case 58.7mm x 91.3mm x 17.1mm (excluding protrusions)
PCB: 2.1 x 3.3 x 0.4 inches (54 x 85.5 x 11 mm) (not including connector and switch).
Measuring frequency: 10KHz -1.5GHz
RF Output: 0 dbm (±2 dbm)
Measuring range: 70dB (50kHz-300MHz), 60dB (300M-900MHz), 40dB (0.9G-1.5GHz);
Port SWR: < 1.1
Display: 2.8" TFT (320 x240)
USB interface USB type C communication mode: CDC (serial)
Power supply: USB 5V 120mA, built-in 650mA-h battery, charging current 300mA
Number of Scan Points: 101 (fixed)
Display Tracking: 4, Marking: 4, Settings: 5.
Frequency Tolerance: <2.5ppm
Frequency Stability: <0.5ppm
Micro SD Card to store measured data - Support 32GB memory card
You can use the MicroSD card to store measurement data in the SNP format or save screen shots in BMP format.The MicroSD card uses SPI mode and only supports FAT or FAT32 formatted at less than 32 GB.
Besides, unlike the previous version, it can display the date and time of vna, also convenient for recording and storing data.
What can you get?
1 x Antenna Analyzer Host
2X 20cm SMA Male to Male RG174 RF Cable
2X SMA Female to Female Connector
1 x Short SMA simple calibration kit.
1 X SMA Simple Calibration Kit OPEN
1X SMA Simple Calibration Kit LOAD
1X USB Type-C Data Cable
1X USB-C to USB-C Line
1X Touch Paddle
HF VHF UHF Antenna Analyzer Measurement
The main function of the default firmware is used to measure the antenna performance.The TX/RX method can measure S11 and S21 parameters.If you need to get S12 and S22, you need to change the wiring of the transceiver port manually.
Support Android Phone & PC Software Control
Compared to the previous version, it supports the time domain analysis function (TDR), making it more convenient to connect with your phone.Compatible with most android phones.Support Windows computer control.
